A simple model of drainage flow in a valley     

Takeshi Sato  Junsei Kondo 《Boundary-Layer Meteorology》1988,45(4):355-369

A model of the drainage flow in a valley under calm conditions has been developed on the basis of the conservation laws of mass, momentum, and heat. The inflow of mass and heat from side-slopes is incorporated, and the momentum and sensible heat exchanges between valley drainage flow and valley floor are parameterized.The characteristic velocity of valley drainage flow is expressed in terms of the following parameters: three potential temperature differences representing the temperature field in the valey; topographic parameters of the valley; mean bulk coefficients representing the aerodynamic conditions of the valley floor; and the stability of the ambient atmosphere. The characteristic thickness includes additional parameters of side-slope flow.That the model satisfactorily predicts the characteristic thickness and velocity is shown from comparison with observations from valleys several hundred meters to a few hundred kilometers long.  相似文献   

Attenuation of compressional waves in peridotite measured as a function of temperature at 200 MPa   总被引：3，自引：0，他引：3  

Hiroki Sato  I. Selwyn Sacks  Tsutomu Murase  Gregory Muncill  Hiroyuki Fukuyama 《Pure and Applied Geophysics》1988,128(1-2):433-447

A technique has been developed to determine attenuation in rocks at high temperature using a gas-media, high-pressure apparatus. A pulse transmission technique and a spectral ratio method are used to study compressional seismic properties of rocks. Seismic waves are transmitted to and from the sample through buffer rods of mullite. The effect of seismic wave reflections within the sample assembly are cancelled out by taking ratios of the spectra measured at different temperatures. In order to obtain good signal-to-noise ratio for resolving the attenuation at high pressure and temperature, special care is taken in the sample assembly and the ultrasonic coupling between the sample, buffer rods and transducers. A very tight connection of the sample-buffer rod-transducer is essential for obtaining high frequency signals (>300 kHz) at high temperature. A small mass is attached to each outside end of the transducer to drive low frequency signals (<250 kHz) into the sample. Before attenuation measurements, the sample and the buffer rods are tightly compacted in a platinum tube at high pressure and room temperature to ensure pressure seal of the sample assembly. The frequency range of measurement covers 50 to 450 kHz for the sample. Attenuation is very small in the buffer rod compared to the sample for the entire temperature range of the study. Because of the small attenuation, a wide frequency band of 50 kHz to 3.2 MHz can be covered for investigating the attenuation in the buffer rod. The technique has been used to measure attenuation at high confining pressure, and temperatures including sub- and hyper-solidus of upper mantle rocks. Therefore, effects of partial melting on attenuation can be studied.The method is applied to the attenuation measurement in a peridotite as a function of temperature to 1225°C at 200 MPa confining pressure. At high temperature, signal amplitude decays more rapidly at high frequency than at low frequency, from which attenuation (andQ) can be determined using a spectral ratio method. No frequency dependence ofQ is resolved for both the sample and the buffer rod over the entire temperature and frequency ranges of the measurement. The results show thatQ decreases rapidly with increasing temperature even in the temperature range below the solidus of peridotites. Such temperature sensitivity ofQ is probably more useful to probe thermal structure in the upper mantle than that of conductivity at temperatures below the solidus. The results in this study are compared with available seismic velocity, electrical conductivity and solidus data for peridotites, suggesting that there is no discontinuous change in both mechanical and electrical properties of peridotites at the solidus temperature. Even at hypersolidus temperatures, it appears that velocity drops and conductivity increases continuously (not abruptly) with increasing melt fraction. This implies that mechanical and electrical properties of the upper mantle will gradually change at the boundary where the geotherm crosses the solidus.  相似文献   

Preliminary results of a study on the responses of sedimentary rocks to shaft excavation     

Kozo Sugihara  Hisaya Yoshioka  Hiroya Matsui  Toshinori Sato 《Engineering Geology》1993,35(3-4):223-228

A shaft with a diameter of 6 m and a depth of 150 m was excavated in sedimentary rocks. Anin situ study was carried out to identify the size and rock properties of the zone disturbed by the excavation and to estimate the applicability of existing methods for measuring and modelling such a zone. The study detected displacements and changes in the properties of the rock within about 1 m of the shaft wall. Numerical analysis using a model of continuous rock mass can simulate some features of disturbance due to excavation, although slight discrepancies exist between the measured and analysed results. The excavation disturbance detected in this study is probably due to fracturing, the redistribution of stress and undersaturation. However, the relationships between the disturbance due to excavation and these processes have not been quantified. The existing methods for measurements and numerical analysis can provide important information on the disturbance due to excavation but need to be improved to understand disturbance due to excavation further.  相似文献   

Formulation of the multiple non-isotropic scattering process in 3-D space on the basis of energy transport theory   总被引：1，自引：0，他引：1  

Haruo Sato 《Geophysical Journal International》1995,121(2):523-531

  相似文献   

A kinematic model for evolution of island arc-trench systems   总被引：1，自引：0，他引：1  

Toshinori Sato  Mitsuhiro Matsu'ura 《Geophysical Journal International》1993,114(3):512-530

  相似文献   

Energy Transportation In One- and Two-Dimensional Scattering Media: Analytic Solutions of the Multiple Isotropic Scattering Model     

Haruo Sato 《Geophysical Journal International》1993,112(1):141-146

  相似文献   

Olivine phenocrysts in some Cameroonian Basalts—implications for primary magma composition     

Hiroaki Sato  Felix Tchoua  Minoru Kusakabe 《Mineralogy and Petrology》1991,44(3-4):253-269

Summary The chemical composition of olivine phenocrysts was determined for 13 basaltic samples taken from the central part of the Cameroon Volcanic line to estimate the compositions of the primary olivine phenocrysts and the primary magmas. The Mg/(Mg + Fe) ratios of the olivines attain 0.91, though many of the magnesian olivines are identified on a textural basis as xenocrysts from peridotite inclusions. Most magnesian olivine phenocrysts have Mg/(Mg + Fe) ratios of 0.87–0.88 and NiO contents of 0.32–0.35 wt %. The NiO versus Mg/(Mg + Fe) ratios of the olivines can be used to estimate the compositions of the primary phenocrysts in a range of Mg/(Mg + Fe) = 0.88–0.90. Assuming the Fe(3)/(total Fe) ratios of the magmas are 0.17–0.25, which is estimated from the Fe-Mg partitioning between plagioclase and groundmass, the compositions of the primary magmas were obtained from the Fe²⁺-Mg partition equilibrium with the primary olivine phenocrysts. The primary magmas of the Cameroonian basalts have 13.5 ± 4.0 wt MgO, which is similar to the compositions of basalts with highest MgO contents reported so far from the Cameroon volcanic line.

---

Olivin Kristalle in einigen Basalten aus Kamerun: Hinweise auf die Zusammensetzung des primitiven Magmas

Zusammenfassung Die chemische Zusammensetzung von Olivin Phenokristallen wurde in 13 Basalt-Proben, die vom Zentralteil .des Kamerun-Vulkangürtels stammen, bestimmt, um Hinweise auf die Zusammensetzung der primären Olivineinsprenglinge and des primären Magmas zu erlangen. Die Mg/(Mg + Fe) Verhältnisse der Olivine reichen bis 0.91, obwohl viefle dieser Mg-Olivine auf Grund textureller Kriterien als aus Peridotit-Einschlüssen stammende Xenokristalle zu identifizieren sind. Die Mg/(Mg + Fe) Verhältnsse der Hauptmasse der Olivin-Phenokristalle liegen im Bereich von 0.87 bis 0.88, die Ni0 Gehalte zwischen 0.32 und 0.35 Gew %. Die Ni0 gegen Mg/(Mg + Fe) Verhältnisse eignen sich zur Abschätzung der Zusammensetzung der primären Phenokristalle, solange die Mg/(Mg + Fe) Verhältnisse im Bereich von 0.88 bis 0.90 liegen. Die Zusammensetzung des Primärmagmas wurde mittels der Fe²⁺-Mg-Verteilung zwischen dem Magma und den sich mit dem Magma im Gleichgewicht befindlichen primären Olivinkristallen unter der Annahme eines Fe³⁺/Fe total Verhältnisses von 0.17–0.25, welches sich aus der Mg-Fe Verteilung zwischen Plagioklas und Grundmasse ergibt, bestimmt. Demnach ergibt sich für das primäre Magma der Kamerun Basalte ein MgO Gehalt von 13.5 + 4.0 Gew%. Dieser Wert ist mit der Zusammensetzung von Basalten mit höchsten MgO-Gehalten, wie sie bisher vom Kamerun-Vulkangürtel berichtet worden sind, vergleichbar.

---

---

With 6 Figures  相似文献   

Application of Convergence Confinement Analysis to the study of preceding displacement of a squeezing rock tunnel   总被引：4，自引：0，他引：4  

T. Kitagawa  T. Kumeta  T. Ichizyo  S. Soga  M. Sato  M. Yasukawa 《Rock Mechanics and Rock Engineering》1991,24(1):31-51

Summary This paper deals with a study on the geomechanical behavior of the rock mass around the tunnel. The Convergence Confinement Analysis is one of the most appropriate way to estimate this behavior. Elasto-plastic models proposed by Hoek and Brown, Egger and Kastner were adopted in this study.Measurements of the preceding displacement were performed in a road tunnel in Japan, the geology of which is Neogene squeezing mudstone. The measured data was compared with the results of Convergence Confinement Analysis.The preceding displacement was about 40% against the upper bench face converged displacement and 17% against the final converged displacement. Meanwhile, it increased drastically in lower bench excavation step.Back analysis was also executed to calculate the extension of the plastic zone of the rock mass, which was half of that estimated by Convergence Confinement Analysis in upper bench excavation step. But, in lower bench excavation step, the results of the two analyses were very similar. The support pressure and support stiffness were also calculated.  相似文献   

Ultrasonic measurements of V_p and Q_p: relaxation spectrum of complex modulus on basalt melts     

Hiroki Sato  Murli H. Manghnani 《Physics of the Earth and Planetary Interiors》1985,41(1):18-33

Ultrasonic compressional wave velocity V_p and quality factor Q_p have been measured in alkali basalt, olivine basalt and basic andesite melts in the frequency range of 3.4–22 MHz and in the temperature range of 1100–1400°C. Velocity and attenuation of the melts depend on frequency and temperature, showing that there are relaxation mechanisms in the melts. Complex moduli are calculated from the ultrasonic data. The results fit well a complex modulus of Arrhenius temperature dependence with log-normal Gaussian distribution in relaxation times of attenuation. The analysis yields average relaxation time, its activation energy, relaxed modulus, unrelaxed modulus and width of Gaussian distribution in relaxation times. Relaxed modulus is smaller (17.5 GPa) for basic andesite melt of high silica and high alumina contents than for the other two basalt melts (18.1–18.4 GPa). The most probable relaxation times decrease from ～ 3 × 10^?10 s for basic andesite to ～ 10^?11 s for alkali basalt at 1400°C. Activation energies of attenuation, ranging from 270 to 340 kJ mol^?1 in the three melts, are highest in basic andesite. Longitudinal viscosity values and their temperature dependences are also calculated from V_p and Q_p data. The volume viscosity values are estimated from the data using the shear viscosity values. Longitudinal, volume and shear viscosities and their activation energies are highest in the basic andesite melt of the most polymerized structure.  相似文献   

Anomalous hydrogen emissions from the San Andreas fault observed at the Cienega Winery,central California     

Motoaki Sato  A. J. Sutton  K. A. McGee 《Pure and Applied Geophysics》1984,122(2-4):376-391

We began continuous monitoring of H₂ concentration in soil along the San Andreas and Calaveras faults in central California in December 1980, using small H₂/O₂ fuel-cell sensors. Ten monitoring stations deployed to date have shown that anomalous H₂ emissions take place occasionally in addition to diurnal changes. Among the ten sites, the Cienega Winery site has produced data that are characterized by very small diurnal changes, a stable baseline, and remarkably distinct spike-like H₂ anomalies since its installation in July 1982. A major peak appeared on 1–10 November 1982, and another on 3 April 1983, and a medium peak on 1 November 1983. The occurrences of these peaks coincided with periods of very low seismicity within a radius of 50 km from the site. In order to methodically assess how these peaks are related to earthquakes, three H₂ degassing models were examined. A plausible correlational pattern was obtained by using a model that (1) adopts a hemicircular spreading pattern of H₂ along an incipient fracture plane from the hypocenter of an earthquake, (2) relies on the FeO–H₂O reaction for H₂ generation, and (3) relates the accumulated amount of H₂ to the mass of serpentinization of underlying ophiolitic rocks; the mass was tentatively assumed to be proportional to the seismic energy of the earthquake.  相似文献